top of page


"Get Hooked on Affordable, High-Quality Graph Mounts with Str8 Up Mounts!" Tournament tested.
All mounts are universal for graphs, but some drilling might be required. Hardware is included to attach the riser to the dual plate. Deck mounting hardware is not included. Make sure you tighten the bolts so the flange nuts cut into the aluminum.
NOTE: When attaching your factory gimbals to the mount, I recommend using 1/4-20 x 1" or 1.5" SS bolts with nylon nuts and washers.
Str8 Up Mounts.... USED BY
CHAMPIONS!
Save 15% on all orders until Dec. 1 Use code Thanks at checkout.





Installation Instructions
Please follow these instructions carefully. If you have any questions, please feel free to contact us and we will gladly assist.
Always remember to dry-fit everything before you secure everything down to make sure that cables and the trolling motor clear your graphs/mount. As well as centering the dual plate on the mount to balance the weight distribution.
Do not use wood screws to attach the mount to the deck.
For best results use recommended hardware sold here or similar.
*PLEASE NOTE: DO NOT USE POWER TOOLS TO TIGHTEN THE NYLON NUTS - THEY WILL SEIZE UP.
Recommended installation hardware to attach to mount deck.
6 - 1/4 -20 x 2"or 3" Stainless Steel Fully Threaded Bolts
12 - 1/4" Stainless Steel Flat Washers
6 - 1/4-20 Nylon Insert Nut Type Stainless Steel
Tools needed:
5/32" Allen wrench
7/16" socket or box wrench
Please note: Str8-Up Mounts is not responsible for any incorrect installations. Contact us with any installation questions and we will be happy to assist.


For Ranger boats you must either dig out the foam in the areas you are bolting to or use anchor bolts to properly secure to the deck.
PRE-DRILLED HOLES ON THE RISERS ARE A STARTING POINT AND ARE NOT MADE FOR ANY SPECIFIC MANUFACTURERS GIMBAL HOLES. THEY ARE ONLY A STARTING POINT
bottom of page